|
ИСТИНА |
Войти в систему Регистрация |
Интеллектуальная Система Тематического Исследования НАукометрических данных |
||
Near infrared imager for spectral and polarization analysis of planetary surfacesстатья
Информация о цитировании статьи получена из
Web of Science,
Scopus
Дата последнего поиска статьи во внешних источниках: 23 января 2018 г.
- Авторы: Belyaev D.A., Yushkov K.B., Anikin S.P., Evdokimova N.A., Potanin S.A., Dobrolenskiy Y.S., Korablev O.I., Molchanov V.Ya, Mantsevich S.N.
- Сборник: Proc. of SPIE
- Серия: Sensors, Systems, and Next-Generation Satellites XXI
- Том: 10423
- Год издания: 2017
- Место издания: SPIE Remote Sensing Warsaw, Poland
- Первая страница: 104231Y-1
- Последняя страница: 104231Y-6
- DOI: 10.1117/12.2277917
- Аннотация: We propose a concept of an imaging near-IR spectrometer for sensing of planetary surfaces. This instrument is intended to analyze mineralogical and, in some cases, petrographic composition of the upper surface layer in the planetary regolith; to identify and monitor OH/H2O bearing minerals and water adsorption in this layer. The scheme of the spectrometer was designed on a basis of an acousto-optic tunable filter (AOTF) that allows imaging of samples in two orthogonal polarization planes simultaneously. Images are registered as a light (e.g. solar one) reflected and scattered from an observed target in the near infrared spectral range. The AOTF’s electrical tuning provides fast and flexible spectral scanning of an image through whole the range analyzed – potentially, ten microseconds per a spectral point. Thus, it is possible to explore reflectance spectra of specified areas on a sample and to detect its minerals composition and microstructure variations. In parallel, one can estimate polarization contrast at different wavelengths thanks to the AOTF’s birefringence properties. In this paper we report design and performance of a laboratory prototype for the near-IR spectro-polarimeteric imaging AOTF system operating in the spectral range from 0.8 to 1.75 μm. Reflectance spectra of some minerals were measured with the spectral resolution of 100 cm-1 (passband 10 nm at 1 μm). When imaging samples the spatial resolution as high as 0.5 mm was reached at the target distance of one meter. It corresponds to 100 by 100 resolving elements on the CCD matrix for each of two polarizations of the reflected light. Such a concept is also being designed for the spectral range from 1.7 to 3.5 μm. © (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
- Добавил в систему: Манцевич Сергей Николаевич