Fabrication methods of the polygonal masonry of large tightly-fitted stone blocks with curved surface interfaces in megalithic structures of Peru

Lapshin, R.V.

Автор: Lapshin R.V.
Журнал: Preprints
Год издания: 2024
Первая страница: 1
Последняя страница: 66
Номер статьи: 2021080087
DOI: 10.20944/preprints202108.0087.v10
Аннотация: The article suggests methods that allow creating the most complicated type of polygonal masonry existing in Peru. This masonry type consists of large stone blocks weighing from several hundred kilograms to several tons fitted close to each other almost without a gap between complicated curved surfaces over a large area. The work provides a description of techniques, which apparently were used by builders who arrived from Europe. The techniques under discussion are based on the use of a reduced clay model, 3D-pantograph, topography translator and replicas. The use of the topography translator, reduced clay model and pantograph provides not only the unique appearance and high quality of the masonry of large blocks, but also allows to increase productivity of the builders significantly. As mechanisms for coping-scaling three-dimensional objects are known since the beginning of the 18th century, the stone structures under consideration should be approximately dated by this time. The remaining simpler types of the polygonal masonry, when the stones are small or the fitted surfaces are almost flat, or the stones contact each other over a small area, or there are significant gaps between the stones, are quite consistent with the well-known methods of stone processing at that or earlier time and, therefore, they do not require any additional explanations. The Fortress Sacsayhuaman is considered as an example of early star fortresses that has survived to our time. The polygonal structures in Peru, the polygonal Face Towers and polygonal bas-reliefs in Cambodia, the symmetrical statues of pharaohs in Egypt are based on the same construction technologies, working methods, tools and technical contrivances. Therefore, with a high probability one can state that all these monuments were created by the same group of architects, sculptors, builders and could not have appeared before the 17th century.
Добавил в систему: Лапшин Ростислав Владимирович

	ИСТИНА	Войти в систему Регистрация
	Интеллектуальная Система Тематического Исследования НАукометрических данных
	Главная Поиск Статистика О проекте Помощь

ИСТИНА

Интеллектуальная Система Тематического Исследования НАукометрических данных

Fabrication methods of the polygonal masonry of large tightly-fitted stone blocks with curved surface interfaces in megalithic structures of Peruстатья Электронная публикация

Прикрепленные файлы