Study of the Plastic Formation in the Production of Thermoelectric Material Based on Bismuth Tellurideстатья

Информация о цитировании статьи получена из Scopus
Статья опубликована в журнале из списка Web of Science и/или Scopus
Дата последнего поиска статьи во внешних источниках: 3 сентября 2019 г.

Работа с статьей


[1] Study of the plastic formation in the production of thermoelectric material based on bismuth telluride / D. I. Bogomolov, V. T. Bublik, N. A. Verezub et al. // Russian Microelectronics. — 2018. — Vol. 47, no. 8. — P. 566–574. We carry out an experimental-theoretical study of the process of the equal-channel angular pressing ECAP) to obtain a bismuth-telluride-based thermoelectric (TE) material. A brief review of the mathematical modeling of the ECAP process is given, and the effect of the design features and temperature of ECAP regimes on the formation of plastic is studied. The results of calculations of the thermally stressed state of the samples at different stages of the ECAP process are presented. The calculations for the ECAP process are carried out using the Lagrange finite element mesh. During the calculation, the mesh is adjusted to the geometry of the die, becoming rarer or finer depending on the magnitude of the plastic deformation to satisfy the specified calculation accuracy and the convergence of the iterative process. We discuss the results of an experimental study of the structure and properties of the samples obtained with the help of ECAP using various methods (X-ray diffractometry and scanning electron microscopy). The TE characteristics of the obtained materials are measured by the Harman method. Comparative methodological calculations of the ECAP process for a bismuth-telluride-based TE material with a change in the parameters determining the formation of grains are performed (the critical plastic deformation as a function of temperature and the power-law dependence of the rate of this deformation). This allowed us to adjust the design model of the ECAP process using the grain size measurements in the TE material. The results of the calculation of the process of grain formation at different temperatures of plastic molding are presented and compared with the experimental data. The practical result of this research is the improved geometry of the die punch and the validated technological regimes of plastic deformation, which allowed obtaining samples with high TE efficiency valuеs. [ DOI ]

Публикация в формате сохранить в файл сохранить в файл сохранить в файл сохранить в файл сохранить в файл сохранить в файл скрыть