Fatigue fracture model for weak fiber/matrix interface composite within three point bending testстатья

Информация о цитировании статьи получена из Scopus, Web of Science
Статья опубликована в журнале из списка Web of Science и/или Scopus
Дата последнего поиска статьи во внешних источниках: 19 июля 2013 г.

Работа с статьей


[1] Khvostunkov K. A., Shpenev A. G. Fatigue fracture model for weak fiber/matrix interface composite within three point bending test // Key Engineering Materials. — 2011. — Vol. 465. — P. 161–164. The model of fiber/matrix interface degradation due to abrasive wear of fiber/matrix contact surfaces is presented. This model explains weak interface composites low cycle fatigue effect and cycle to cycle creep rate increase. The authors consider the results of experiments series carried out at the Institute of Solid State Physics located at Chernogolovka town. During this experiments series some weak interface nickel-oxide composite samples were subjected to a cyclic load in the course of a three point bending test and the samples central point set displacement rate was registered. Then there was created a fiber-matrix interface cyclic degradation model. The authors compared their theoretical assumptions to experimental data (for reference kindly see the below calculations) and evaluated low cycle fatigue influence on composite fracture.

Публикация в формате сохранить в файл сохранить в файл сохранить в файл сохранить в файл сохранить в файл сохранить в файл скрыть