|
ИСТИНА |
Войти в систему Регистрация |
Интеллектуальная Система Тематического Исследования НАукометрических данных |
||
Microwave stabilization of a HEB mixer in a pulse-tube cryocoolerстатья
- Авторы: Shurakov A., Tong C.Y.E, Blundell R., Kaurova N., Voronov B., Goltsman G.
- Журнал: IEEE Transactions on Applied Superconductivity
- Том: 23
- Номер: 6416025
- Год издания: 2013
- Издательство: Institute of Electrical and Electronics Engineers
- Местоположение издательства: Piscataway, NJ, United States
- DOI: 10.1109/TASC.2013.2241591
- Аннотация: We report the results of our study of the stability of an 800 GHz hot electron bolometer (HEB) mixer cooled with a pulse-tube cryocooler. Pulse-tube cryocoolers introduce temperature fluctuations as well as mechanical vibrations at a frequency of 1 Hz, both of which can cause receiver gain fluctuations at that frequency. In our system, the motor of the cryocooler was separated from the cryostat to minimize mechanical vibrations, leaving thermal effects as the dominant source of the receiver gain fluctuations. We measured root mean square temperature variations of the 4 K stage of 7 mK. The HEB mixer was pumped by a solid state local oscillator at 810 GHz. The root mean square current fluctuations at the low noise operating point (1.50 mV, 56.5 μA) were ∼ 0.12μA, and were predominantly due to thermal fluctuations. To stabilize the bias current, microwave radiation was injected to the HEB mixer. The injected power level was set by a proportional-integral-derivative controller, which completely compensates for the bias current oscillations induced by the pulse-tube cryocooler. Significant improvement in the Allan variance of the receiver output power was obtained, and an Allan time of 5 s was measured.
- Добавил в систему: Гольцман Григорий Наумович